Please wait while the page loads...

Will the check engine light reset itself?

The check engine light on your Acura will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going factual, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your Acura light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to David McDavid Acura of Austin so the light and code can be double-checked and reset.

Acura Check Engine Light

If the check engine light in your Acura starts flashing, that means that the problem needs immediate attention and your Acura should be brought in rapidly. A flashing light indicates that the problem is serious and if not taken care of rapidly may result in central damage to the vehicle. This blinking light usually indicates a rigid engine misfire allowing unburned fuel to be jettisoned into the exhaust system. There it can swiftly raise the temperature of the catalytic converter to a point where break is probable, requiring an fancy repair. Some owners ask if spark plugs cause the check engine light to flash? This can exactly be the cause. A bad, historic or dirty spark plug can cause the engine to misfire. If your check engine light is shining, please contact our team of automotive advisors at David McDavid Acura of Austin swiftly by calling 5126436468. If the problem is ignored or you continue to commute, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very pricey repair.

What could cause the check engine light to come on in a Acura?

When your check engine light comes on, this could be as plain as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a risky problem that could cause risky wear and tear to your engine and come with a big repair bill. Depending on your make and model, the check engine light will illuminate or blink. A persistent glow mostly means something less risky but a flashing check engine light illustrates that your vehicle’s engine is in risky trouble and service is essential hastily. If your check engine light is flashing in your Acura, we extremely recommend not to drive the car and schedule Acura service today. Below is a list of the most prevailing reasons your check engine light can come on:

  • Your O2 Sensor (Oxygen Sensor) needs to be changed. The Oxygen sensor, known as the O2 sensor, measures the sum of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your car will be less productive when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your Acura 's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to prefer the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your Acura ’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is consistently caused by neglected maintenance, which is why David McDavid Acura of Austin offers a complimentary multi-point inspection with every Acura service. If you have an issue with your catalytic converter and don't get it revamped, your Acura will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause contrasting problems from overheating.
  • The battery is scanty or dead. The battery in your Acura is every meaningful. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't really require maintenance. The estimate of a new one depends on the type of Acura you drive, but check our humane service coupons and specials.
  • Issues with all aftermarket items. An aftermarket alarm, exhaust or contrasting item can wreak havoc on your Acura if it’s not installed properly. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prohibit the car from starting. If these issues sound commonplace, transport your to Acura and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing all issue. Getting accessories, notably aftermarket parts and accessories, or using OEM parts first place might cost a little bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • New Spark Plugs or Plug Wires are needed for your Acura. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your car. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or classical, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, primary to more expensive repairs.
  • Your mass airflow sensor (known as MAF) needs to be changed. The mass airflow sensor in your Acura is what determines how much fuel is needed to run your engine efficiently by measuring the sum of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to cognizant changes, like altitude. If your Acura is having trouble starting, idling rough or has a quick change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Your Acura has a vacuum leak. Every Acura has a vacuum system that performs a wide mixture of functions. The vacuum system also helps lower damaging emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, notably if they’re exposed to enormous heat or extreme nimble.
  • One of the most traditional and frequent cause is that your Acura gas cap is loose, damaged or missing. The gas cap for your Acura serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is classical or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on expeditiously after you put gas in your Acura, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is commonly between $88 and $111. The terrific news, David McDavid Acura of Austin offers complimentary multi-point inspections and free diagnostics, in most cases, to help determine the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not well tightened to a more unhealthy failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it terrific to get the contractual code reading and diagnosis.

Acura Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also common as the OBD (on-board computer diagnostic system) in your. There are hundreds of precise codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling vital diagnostics will give you positive knowledge about your car and will also allow that Check Engine Light to do what it is fully supposed to do: be your guide. Unfortunately, clear and practical car symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of cogent OBD codes, there are also hundreds of cogent reasons for the light, including:

  • Ignition system faults
  • Fuel and air metering systems problems
  • Computer output circuit issues
  • O2 Sensor
  • Loose Gas Cap or Missing Gas Cap
  • Old Battery
  • Emissions controls issues
  • Bad Spark Plugs
  • Transmission issues

This is why it is vital for someone who does not have a lot of automotive knowledge to not assume what a code means. Call David McDavid Acura of Austin at 5126436468 today or schedule your check engine light service online today! If the engine light comes on due to a scrupulous concern, you risk bad your car further by not repairing the issue right away. When your check engine light comes on, you should get it checked out expeditiously by a certified Acura mechanic.

Acura Check Engine Light Flashing

Although there are plentiful potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are discrete easy causes including something as easy as a loose gas cap. Divergent easy reasons for a Check Engine Light are damaged oxygen sensor, faulty emissions control part, a malfunction with the fuel injection system, dirty mass airflow sensor, faulty head gasket, or defective spark plugs to name a lot. No matter what is the root cause of the Check Engine Light, we have the Acura Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Acura issue was fixed.

Every Acura was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its laborious systems. The sensors are continually detecting conditions while sending data to the electronic control squad. If the electronic control squad detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; David McDavid Acura of Austin provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Extremely Qualified Service high-tech.

Is it safe to drive your Acura with the check engine light on?

This question is not very convincing because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is often indicated by a consistent glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more abhorrent problem. If the check engine light is glaring, this means that there is a abhorrent issue and it is recommended to service your Acura suddenly. Call the experts at David McDavid Acura of Austin by dialing 5126436468 so you can describe the issues. Or reduce your speed and bring your Acura to our certified mechanics as soon as possible.

Check Engine Light Service Acura

What do you do when you’re driving along in your Acura and suddenly, a yellow light brightens on your dash and says "Check Engine". If you’re like most Acura owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your Acura checked as soon as available. Ignoring that warning could end up causing major damage to fancy engine components.

When your Acura 's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t persistent, a computer turns on your check engine light. This amber or yellow light is ordinarily labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is select with an electronic observe tool that is used by our Acura auto repair mechanics at David McDavid Acura of Austin. There are also a number of somewhat inexpensive code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced professional to indicate the issue and repair it.

How many miles can you drive with the check engine light?

Since each check engine code has its own level of severity, it is not easy to predict how many miles you can drive with the warning light on. If you check engine light is flashing, we advocate that you pull over and contact David McDavid Acura of Austin to help find out if your vehicle is safe to drive in or if we advocate a tow truck. The safest bet is to decipher the code and then plan your strategy accordingly. It could be anything from a harmful sensor to plug wires needing to be interchanged.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your Acura is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few numerous ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light brightens in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your Acura. Some of these include ignition timing, controlling engine speed, shifting automatic transmissions and implementing stability control, just to name a few. With that being said, the check engine light can represent a collection of odd things. It can be as straightforward as your gas cap being loose or as important as engine knocking. If your check engine light is on in your Acura, contact David McDavid Acura of Austin. Contact David McDavid Acura of Austin today! Our Acura service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing.